NC State releases initial PCB test results from Poe Hall, more work to be done to determine extent of exposure for students and staff
NC State has released the first report of PCB test results from Geosyntec Consultants, the consulting firm doing the environmental assessment of Poe Hall.
Posted — UpdatedThe university contracted Geosyntec Consultants to do an environmental assessment in the building, home to the College of Education and Psychology Department, after preliminary testing in November revealed high levels of PCBs, toxic chemicals linked to cancer.
However, experts highlighted to 5 On Your Side that the sampling was done with the HVAC system off and is not reflective of the scenario in which people were exposed to possible contaminants in Poe Hall.
"I have major problems with the method of analysis," said Dr. David Carpenter, a professor at the State University of New York at Albany whose work focuses on the study of environmental causes of human disease.
"The fact that the HVAC system was off and the sampling was done and they still found elevations in samples in air and in swipe samples suggests to me that that sampling analysis underestimates significantly the real exposure people had," Carpenter said.
The Geosyntec report noted in the sampling methodology that EPA methods were followed during testing.
The Geosyntec report says this is a phased investigation and testing with the HVAC system off was the first phase. It’s not clear when we will get results of testing with the HVAC system on, but the report says that is part of the next steps.
- 14 indoor air samples did detect the PCB known as Aroclor-1262, but the university said all levels were below EPA exposure levels for PCBs in schools. It is important to remember that the HVAC system has been off since November 2023 and remained off throughout the testing. This means no dust particles of any kind were circulating through the air handler system.
- 67 surface, or swipe, samples were taken throughout all seven of Poe Hall’s floors. Samples were taken from desktops, books, bathroom counters, air supply vents and several other locations. 25 wipe samples detected Aroclor-1262, but the report says only one was above EPA threshold.
Testing in October showed bulk samples taken in the fifth floor women’s bathroom were 38 times EPA limits, and other bulk samples tested high for PCBs. Recommendations in the new report from Geosyntec indicate bulk samples of potential sources will be collected and analyzed, notably focused on the HVAC system.
Geosyntec recommends turning on the HVAC system to do more air and surface wipe sampling after bulk samples are analyzed.
The final recommendation in the report is to review studies on PCBs to understand the potential human health effects associated with exposure.
Related Topics
• Credits
Copyright 2024 by Capitol Broadcasting Company. All rights reserved. This material may not be published, broadcast, rewritten or redistributed.